The i2O Pump Optimiser is designed to be integrated into a Pump Control system in order to provide an algorithm-derived pump pressure setpoint to maintain required customer levels of service.
Installation of the Pump Optimiser should be carried-out by a suitably-qualified System Integrator or ICA Engineer.
The attached Installation Manual describes how the controller must be installed and includes a checklist to enable the installer to sign-off the installation, confirming that they have completed the installation as described in the manual.
There are two models of Pump Optimiser supported. These are substantially the same, but the correct manual should be used for the model in use as there are minor differences:
- AEPM0003 - supplied up to 2016 - Black or multicoloured i2O Branding
- AEPM0016 - supplied from Q3 2016 - Light Blue "Calm Water" i2O Branding